Hello Guest it is March 28, 2024, 04:53:16 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - kmjcustom

Pages: 1
1
General Mach Discussion / New to Mach and a question
« on: May 23, 2014, 05:03:24 PM »
Hi, im new to Mach 3 and CNC. I built a CNC router and have the controller and motors connected. The problem I have is I have a Toshiba laptap running windows 8. I was reading posts that I need a USB controller, any suggestions? also, does the USB controller replace the controller that came with the motors? Thank you

Pages: 1