Hello Guest it is November 15, 2019, 08:24:16 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - chris850

Pages: 1
1
General Mach Discussion / New to CNC
« on: May 22, 2014, 10:46:23 AM »
I don't know if this is the correct category to post this so please move it to the correct one if its not and sorry. I am new to the cnc world and want to learn more about it. I recently purchase a cnc router/mill/engraver online, I'm using the mach3 pre-purchase from the site and cannot get it to work. I have all the cables installed correctly, the address is correct for the parallel port and still nothing. I've tried using the keyboard to jog the machine around and get no movement. I was sent over a sample g-code from the machine supplier and it will run mach3 with now problem but there is no movement on my machine. I don't know if this forum is for this kind of support, I've just exhausted all other research trying to figure out the problem is with my setup. Thanks for any help that is given!

Pages: 1