1
Mach4 General Discussion / Mach 4 cv tuning wizard slider inoperable
« on: September 05, 2019, 09:19:08 AM »
Good morning, when I go to the cv tuning wizard in mach 4 there are two sliders, the top one is for setting the velocity and the bottom one is for setting cv stop angle. The stop angle slider works just fine but the velocity slider does nothing, meaning when I click on it to move it, it won't move, it stuck in the full left position. The velocity number box just below the slider reads 0.0, when I click in the box and try to type a number it also does nothing. Has anyone else experienced this issue?
I have searched the forum for help and so far come up empty handed.
Not sure if it makes any difference but I have Mach 4 version 4.2.0.4162
Steve
I have searched the forum for help and so far come up empty handed.
Not sure if it makes any difference but I have Mach 4 version 4.2.0.4162
Steve