Hello Guest it is August 20, 2019, 03:34:12 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Mike Irvin

Pages: 1
1
General Mach Discussion / dumb question
« on: September 06, 2014, 10:23:55 PM »
If you scale down a drawing "mach3" scale do you have to scale down the end mill also.
Mike

2
General Mach Discussion / engrave on a bat
« on: August 27, 2014, 05:05:45 PM »
Anyone know of software to engrave on a bat  without a 4th axis

3
General Mach Discussion / 3020t-d PWM
« on: August 02, 2014, 01:51:46 PM »
Any one have info on the PWM on this controler it has two boards and both have connectors that say PWM
Thanks Mike

4
General Mach Discussion / 3020t problem
« on: July 26, 2014, 06:42:17 PM »
I need help i can setup and run but as soon as i reboot i have to reset up the home switches  go to configure ports and pins "check" MAX nc 10 shut down the program restart mach3 go to configure ports and pins "UNcheck" MAX nc 10. then everything is ok this happens on all my computers i tried.  this is a LICENSED copy of MACH3
Mike

Pages: 1