Topics

1

General Mach Discussion / Port 1

« on: May 24, 2014, 06:49:06 PM »

 
Hi all, I am running into a small problem.  I cant use the normal Port 1 for Mach 3 because it is used up by the mother board.  So I need some guidance as to what course of action I should take

2

General Mach Discussion / DRO's show Movement - Stepper Motors Dont Move

« on: May 20, 2014, 08:24:54 PM »

I recently Purchased a Sanven 6040 desktop CNC through Amazon.  I set it up and was able to Jog by using the arrow keys .  I tried to set the X, Y and Z zeros now The DRO's show movement but the stepper motord\s don't budge an inch. Has anybody else experienced this and if so what did you do?
Thanks