Hello Guest it is November 29, 2022, 03:04:58 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - CliffL

Pages: 1
1
General Mach Discussion / Pin assignment
« on: April 30, 2014, 04:06:31 PM »
I have a Anahiem Automation driver Model DPF41BB1. trying to upgrade from 486 to a new Dell XP  I have installed MAch 3 and cannot figure out the pin assignments. This is an old driver that takes two ports to plug into. I can get the machine to move X,Y and Z with the nudge buttons. But I cannot figure the limit switches. The CNC machine is a Digitool machine

Pages: 1