1
General Mach Discussion / Router spindle runs independent from Mach3
« on: April 27, 2014, 05:28:46 AM »
Hi,
I am setting up RhinoCad, Meshcam, and Mach3 with a Chinese router. Everything is slowly coming together but spindle will only run by using inverter control panel on front of router. Any settings in meshcam/ Mach are disregarded by machine and speed can only be controlled by turned knob on controller. Can this be bypassed ? If knob is set anywhere clockwise spindle will start and stop with Mach controls.
Any help greatly appreciated.
Barry
I am setting up RhinoCad, Meshcam, and Mach3 with a Chinese router. Everything is slowly coming together but spindle will only run by using inverter control panel on front of router. Any settings in meshcam/ Mach are disregarded by machine and speed can only be controlled by turned knob on controller. Can this be bypassed ? If knob is set anywhere clockwise spindle will start and stop with Mach controls.
Any help greatly appreciated.
Barry