1
General Mach Discussion / Mach 3 generates sound "gong" signals into my PC repro
« on: May 01, 2014, 04:29:16 AM »
If I run some GCode programs, mach3 generates gong souns quite often ( almoust every input Gcode line ... ) .Its same signal as you can hear sometime (why not every time ?) if you press Mach3 Reset button.
I see that this sound is generated every time when Status text line is changed ( my G code input lines are with comments in brackets and these comments are showed there in status line , however, curious is that not all comments, just some of them ....) .
What is the meaning of this - is it some kind of error message this song, or notification that status is changed ? Should I ignore it ? Is there any way to switch it off in Mach Setup ?
I see that this sound is generated every time when Status text line is changed ( my G code input lines are with comments in brackets and these comments are showed there in status line , however, curious is that not all comments, just some of them ....) .
What is the meaning of this - is it some kind of error message this song, or notification that status is changed ? Should I ignore it ? Is there any way to switch it off in Mach Setup ?