1
General Mach Discussion / Screen4 and Win 11 bug
« on: January 16, 2024, 10:06:19 PM »
Opening a .set file from a mach3 install on win 11 pops up an error exclamation point, which I believe should also read unrecognized file. Tried it on one of the screen download from the mach site and got the same error. If I create a new file and save it, it will open in screen4 without issue. Got the same results on a second win 11 machine
Copied the 1024.set file to a thumb drive and tried it on a win10 machine, loaded and edited without issue.
Is this a bug or a win11 issue?
I didn't find this issue on the forum so guessed this was the right spot.
Copied the 1024.set file to a thumb drive and tried it on a win10 machine, loaded and edited without issue.
Is this a bug or a win11 issue?
I didn't find this issue on the forum so guessed this was the right spot.