Hello Guest it is April 18, 2024, 03:29:15 PM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - MDS2880

Pages: 1
1
General Mach Discussion / Mach Running Status
« on: July 15, 2015, 12:36:41 PM »
I want to generate a signal that Mach is running a program. Should I use LED804 (Start LED) or LED999 (Movement LED)? What is the functional difference between the two? What starts/stops each one?

2
General Mach Discussion / Mach3 executing commands not issued
« on: April 11, 2014, 02:48:48 PM »
Looking to get some help with my machine...

While running a program, Mach3 occasionally stops executing the written code and begins to SLOWLY move any number of axes in random directions. After resetting the program and rebooting the computer the program will run flawlessly for many cycles. Eventually, though, the same behavior begins to show up again. Any thoughts on what causes this to occur?

Pages: 1