1
General Mach Discussion / G-Code streaming VIA USB
« on: April 09, 2014, 07:50:36 PM »
Hey guys...
Just wondering if anyone has tried the alternatives out there with any of the available 3D printer hardware.
basicly ditching the old and outdated serial ports for newer hardware.
OPTIONS:
- Arduino Due and Ramps FD
- Beagle Bone Black and T-Bone
- Beagle Bone Black and CRAMPS
RaspberryPie and the Beagle Bone is just the beginning to these mini computing and slowly all side are joining in...
Intel already stepped up with the Galileo and Arduino is bringing their new Tre to the table.
And this is just the beginning !
Any of these options are mostly open source and fairly cheap!
Input please...
Just wondering if anyone has tried the alternatives out there with any of the available 3D printer hardware.
basicly ditching the old and outdated serial ports for newer hardware.
OPTIONS:
- Arduino Due and Ramps FD
- Beagle Bone Black and T-Bone
- Beagle Bone Black and CRAMPS
RaspberryPie and the Beagle Bone is just the beginning to these mini computing and slowly all side are joining in...
Intel already stepped up with the Galileo and Arduino is bringing their new Tre to the table.
And this is just the beginning !
Any of these options are mostly open source and fairly cheap!
Input please...