Hello Guest it is March 29, 2024, 04:36:10 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Zero3

Pages: 1
1
Hi!

Being completely new to cnc and steppers in general, i have a very basic question which i have not found answered elsewhere (even after extensive searching).

I have wired a stepper motor and driver to a power supply as seen in the following picture:



Now i am trying to define in Mach3 which pins of the LPT port


are supposed to belong to the x axis:




In this case, the first and second pin of the LPT port are my "step pin" resp. "dir Pin".

How do i connect those pins to the driver?

My driver http://www.ebay.de/itm/CNC-Router-Single-Axis-TB6560-3-5A-2-Phase-Stepper-Motor-Driver-Board-Controller-/261160006615 has six pins still available:

EN+
EN-
DUR
DIR+
PUL-
PUL+

So, how do i connect those? Is there any basic wiing or scematic?

Yeah i know i must sound kinda stupid, as this question is probably trivial to most of you. However, i am totally lost. Please help me out!


Best regards,
Andy

Pages: 1