Guest
Show Posts
1
G-Code, CAD, and CAM discussions / HELP! Same code, different result
« on: May 13, 2014, 03:15:58 AM »
Hi
Hope someone can help! I make my g-code for a diy router in RhinoCAM 2012. Now I have some 10mm holes to make (not drilling) with a 6 mm wood router bit. The code looks fine in RhinoCam and also checked it in OpenSCAM. But when opened in Mach3 it looks as if the X0 Y0 Z0 position of the axis are now the center of all diameters of the holes and the position of the holes have become a point on the diameter!!? Really absurd. Ofcourse this way it goes more then beyond my table workspace, and I dont know how to fix it?
So anybody has experienced this strange effect, plz help
Attached is the g-code and a screendump of mach3 preview window
Best regards
Per Petersson
Hope someone can help! I make my g-code for a diy router in RhinoCAM 2012. Now I have some 10mm holes to make (not drilling) with a 6 mm wood router bit. The code looks fine in RhinoCam and also checked it in OpenSCAM. But when opened in Mach3 it looks as if the X0 Y0 Z0 position of the axis are now the center of all diameters of the holes and the position of the holes have become a point on the diameter!!? Really absurd. Ofcourse this way it goes more then beyond my table workspace, and I dont know how to fix it?
So anybody has experienced this strange effect, plz help
Attached is the g-code and a screendump of mach3 preview window
Best regards
Per Petersson