Guest
Show Posts
1
General Mach Discussion / Problems With homing out the machine.
« on: March 16, 2014, 07:14:28 PM »
Machine: Minitech 5 Axis Mill
Software: Mach3
Im currently having problems with homing out the machine with the mach3, when I zero out the machine and home all the axis "X,Y,Z,A,B", I will move the axis for the home position that I have them set at and run the G-code, G28 X0 Y0 Z0 A0 B0 to test the machine to go to the home position that i set it at. and it will go to the home position that I set it at, but when I run the test again G28 X0 Y0 Z0 A0 B0 after moving all the axis it doesn't bring it back to the home position that i set it at it a little bit of on all the axis
Software: Mach3
Im currently having problems with homing out the machine with the mach3, when I zero out the machine and home all the axis "X,Y,Z,A,B", I will move the axis for the home position that I have them set at and run the G-code, G28 X0 Y0 Z0 A0 B0 to test the machine to go to the home position that i set it at. and it will go to the home position that I set it at, but when I run the test again G28 X0 Y0 Z0 A0 B0 after moving all the axis it doesn't bring it back to the home position that i set it at it a little bit of on all the axis