Hello Guest it is March 28, 2024, 04:07:42 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - orangecrush

Pages: 1
1
G-Code, CAD, and CAM discussions / large circles in M3
« on: March 15, 2014, 01:26:56 PM »
I am just getting started with Mach3. Not sure if this is the right place to post this, but I am having a problem with gcode.

I am using Cut3d to generate cutting paths. When the part is cut on my mill I am seeing big circles, which is not the intent. I can also see these circles in the mach 3 window:




The gcode looks fine when viewed in cutviewer:




Pages: 1