Hello Guest it is March 29, 2024, 08:57:22 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - brad.miller78

Pages: 1
1
Mach4 General Discussion / Mach4 - motion steps overflow
« on: March 15, 2016, 07:25:16 AM »
Hi,
Is there anyone who can explain the error of motion steps overflow - check motor speed parameters ?
I have a pokeys56u with postep25 drivers. I open up the diagnostics in the pokeys plugin and there doesn't seem to be any issue with the usb connection.
I am running @ 1500 mm/min, I can run mach3 @ 2000 mm/min with the same motor settings.
Any help would be appreciated.
Cheers
Brad

2
General Mach Discussion / Feed rate override encoder delay issue
« on: March 01, 2016, 08:39:01 PM »
Hi,
I have setup the trial of mach3 with pokeys56u incl. plugin. My issue is that I have set up a rotary encoder to control the feedrate override and there seems to be a fair delay from encoder movement to physical change in the feedrate. The feed rate % on mach3 changes straight away though. I am using a pokeys56u with PoExtBusOC16CNC and postep 25/30 drivers
I hope someone can help.
Cheer
Brad

3
Hi,
I have had a search and can't seem to find any info. I have downloaded the trial of both mach3 and mach4 as well as the pokeys plugins.
On Mach3 I was able to map an encoder to control the feed rate override easily, however I can't seem to find a way to do it on Mach4.
Any help would be appreciated,
Cheers


Sent from my iPhone using Tapatalk

Pages: 1