Guest
Show Posts
1
G-Code, CAD, and CAM discussions / Bridges
« on: February 25, 2014, 06:04:48 AM »
Hi All,
Would you know if there's a way, in VisualMill 6.0, to make a soft entry motion at each cut level around a bridge/tab?
Or would you know if there is a way of doing a "triangle" tab like in other software?
It seems that the only option is to go straight down into the material when bridges are milled.
On my CNC system that causes step loss.
Thank you very much,
Regards,
Would you know if there's a way, in VisualMill 6.0, to make a soft entry motion at each cut level around a bridge/tab?
Or would you know if there is a way of doing a "triangle" tab like in other software?
It seems that the only option is to go straight down into the material when bridges are milled.
On my CNC system that causes step loss.
Thank you very much,
Regards,