1
General Mach Discussion / need help! Newbie's problems
« on: May 23, 2007, 09:55:01 AM »
In this moment I am trying to setup my home brewed engraver.
The problem is the scale factor. When I get any G-Code from
CAD prog. the MACH3 engrave it with 1/10 scale factor.
I think I know why.It's because my Microstep Drive.
How I can to setup the X,Y,Z scaling=10 in the MACH soft?
Sorry, I have very poor English.
The problem is the scale factor. When I get any G-Code from
CAD prog. the MACH3 engrave it with 1/10 scale factor.
I think I know why.It's because my Microstep Drive.
How I can to setup the X,Y,Z scaling=10 in the MACH soft?
Sorry, I have very poor English.