Hello Guest it is March 29, 2024, 04:07:17 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - jimengland

Pages: 1
1
General Mach Discussion / Serial port pins not lit
« on: February 18, 2014, 07:51:07 AM »
Hi there everybody.

A long story short, In mach3 diagnostics I only have 5 port1 pins lighting up. I have tried every other port address i have and get different results so i am sure its the right address. I know my machine is all working correctly as i have swapped wires around to test the different motors and can jog them as required but i just dont have enough pins?

Is this a PC hardware problem or a software problem? does anybody know please.....close to throwing it in the river :)

Thank you in advance Jim

Pages: 1