Guest
Show Posts
1
CS-Lab / Problem in CSMIO IP A configuration
« on: August 02, 2015, 10:07:06 PM »
Hello all,
I am retrofittig one old cnc with csmio ip/a
I started tuning controller. I faced some issue and needs your help
I decoupled motor as i wanted to first make it in my control. It runs fine except couple of strange behave
1) i am getting encoder error - please check encoder connection- when i look at diagnosis screen, encoder value is showing with red flashing value (255 and sometimes 14). When i run motor, values are changing as it should be, motor is in control, movement is as desired then what this error indicates? I couldn't find it in manual
2) during trial, sometimes as soon as i press reset in mach, motor start running at full speed at any direction and trips on pid fault. Then i tried swapping encoder in configuration (not actual) and set it back to original, couple of times doing this made motor working again in control
I faced same issues in both axis where i took trial
3) during trial, first run always shorter then expected. I mean giving 10 mm command makes movement of 7 mm in first run, then onwards it runs 10 mm without any error
I am retrofittig one old cnc with csmio ip/a
I started tuning controller. I faced some issue and needs your help
I decoupled motor as i wanted to first make it in my control. It runs fine except couple of strange behave
1) i am getting encoder error - please check encoder connection- when i look at diagnosis screen, encoder value is showing with red flashing value (255 and sometimes 14). When i run motor, values are changing as it should be, motor is in control, movement is as desired then what this error indicates? I couldn't find it in manual
2) during trial, sometimes as soon as i press reset in mach, motor start running at full speed at any direction and trips on pid fault. Then i tried swapping encoder in configuration (not actual) and set it back to original, couple of times doing this made motor working again in control
I faced same issues in both axis where i took trial
3) during trial, first run always shorter then expected. I mean giving 10 mm command makes movement of 7 mm in first run, then onwards it runs 10 mm without any error