1
General Mach Discussion / NEWBIE!! How to round an edge
« on: January 28, 2014, 11:29:39 PM »
Ok, so I'm all proud that I have cut out a rectangle made of plastic and it has rounded corners. I have been trying like crazy to make the outside edges have a rounded edge (without taking to my router table).
Is it a roundover, fillet, bevel?? How can I incorporate this into my NFS programming?
I'm pretty dumb in this whole arena, so, bear with me please.
Thank you in advance.
Is it a roundover, fillet, bevel?? How can I incorporate this into my NFS programming?
I'm pretty dumb in this whole arena, so, bear with me please.
Thank you in advance.