1
PoKeys / Pokeys57CNC Driver Connection
« on: October 30, 2016, 03:05:10 PM »
Hi all
I'm trying to get my steppers running
This is what I did
I have a Pokeys57CNC board
steppers with 4 wires
DM542A drivers from Longsmotor
I can see my Pokeys board in Mach3.
But the steppers are not running yet.
I think I did something wrong with the wiring from pokeys to driver
Pul + (+5V) to the Pokeys 5V motor connector
Pul - to STEP pin on the Pokeys motor connector
Dir + (+5V) to the Pokeys 5V motor connector
Dir - to DIR pin on Pokeys motor connector
I didn't connect the ENBL pins
I'm trying to get my steppers running
This is what I did
I have a Pokeys57CNC board
steppers with 4 wires
DM542A drivers from Longsmotor
I can see my Pokeys board in Mach3.
But the steppers are not running yet.
I think I did something wrong with the wiring from pokeys to driver
Pul + (+5V) to the Pokeys 5V motor connector
Pul - to STEP pin on the Pokeys motor connector
Dir + (+5V) to the Pokeys 5V motor connector
Dir - to DIR pin on Pokeys motor connector
I didn't connect the ENBL pins