1
G-Code, CAD, and CAM discussions / G-Code Skips From Line 88 to M02 Then Back to Line 88
« on: January 17, 2014, 09:38:22 PM »
Hi and thanks for reading this, I am new to Mach 3.
Title says it all. I have 6 files of g-code and they all skip from line 88 to M02 (last line of all files) then back to line 88 and continue on normally. I have reinstalled Mach 3 and that was no help.
All the lines in all the files all look the same so I don't know where to start.
Any ideas?
Mike
Title says it all. I have 6 files of g-code and they all skip from line 88 to M02 (last line of all files) then back to line 88 and continue on normally. I have reinstalled Mach 3 and that was no help.
All the lines in all the files all look the same so I don't know where to start.
Any ideas?
Mike