Hello Guest it is November 28, 2021, 06:14:29 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - ElliotHC

Pages: 1
1
General Mach Discussion / Moving to lower Z point directly after start
« on: January 15, 2014, 10:22:55 AM »
Hi,

I purchased Mach 3 yesterday having re-built my CNC machine and upgrading all the controllers, of course my old software was no good as it was tailored to the old hardware..

I have just tried to do some milling and the strangest thing is happening, Mach3 starts from zero but then drops in the Z axis before cutting. This is of course ruining my piece because it's milling right through it..

Does anyone know what is going on? The code is coming straight from Solidcam and I had no problems before, here is the initial G-Code.


Thanks

%
O5000 (P_CONTOUR_T1.TAP)
( MCV-OP ) (15-JAN-2014)
(SUBROUTINES: O2 .. O0)         
G90 G17
G80 G49 G40
G54
G91 G28 Z0
G90
M01
N1 M6 T1
(TOOL -1- MILL DIA 2.0 R0. MM )
G90 G00 G40 G54
G43 H1 D31 G0 X24.984 Y9.94 Z10. S1000 M3
M8
(---------------------)
(P-CONTOUR-T1 - POCKET)
(---------------------)
   X24.984 Y9.94 Z10.
   Z2.
G1 Z-1. F33
   X29.784 F99.999
   Y10.539
   X20.184
   Y9.94
   X24.984
   Y9.24
   X30.484
   Y11.239
   X19.484
   Y9.24
   X24.984
   Y8.54
   X31.184
   Y11.939
   X18.784
   Y8.54
   X24.984
   Y7.84
   X31.884
   Y12.639
   X18.084
   Y7.84
   X24.984
   Y7.14
   X32.584
   Y13.339
   X17.384
   Y7.14
   X24.984
G0 Z10.

Pages: 1