Hello Guest it is March 28, 2024, 04:40:54 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - masteffen

Pages: 1
1
G-Code, CAD, and CAM discussions / Table not flat to X-Y plane
« on: January 19, 2014, 05:28:18 PM »
I have a routing table X-Y-Z that the cutting surface in not perfectly flat.  So that when i route something into a piece of material the depth of cut is not uniform.

Is there a way in Mach3 to compensate for non-uniform z-axis depth cutting?  I there a g-code that i can use or calibrate to my table for the z-axis?

Mike

Pages: 1