Guest
Show Posts
1
General Mach Discussion / Mach3 CRP4848 Setup Help Needed!
« on: January 05, 2014, 09:27:53 PM »
Hi Everyone!
I have assembled a CNC Router Parts CRP4848 over the last few months, and am having problems getting it running. I can't seem to get the pre-wired Nema 23/G540 electronics to communicate with the Computer/Mach3. Does anyone else use this system? I was trying to make it work using Windows 7 32 Bit with a Rosewill PCI card added. I have since switched to an older computer that uses Windows XP with an on board Parallel Port. If anyone has any advice, Ports/Pins Configurations, or helpful tips, I would really appreciate it!
Thanks,
Shaun
I have assembled a CNC Router Parts CRP4848 over the last few months, and am having problems getting it running. I can't seem to get the pre-wired Nema 23/G540 electronics to communicate with the Computer/Mach3. Does anyone else use this system? I was trying to make it work using Windows 7 32 Bit with a Rosewill PCI card added. I have since switched to an older computer that uses Windows XP with an on board Parallel Port. If anyone has any advice, Ports/Pins Configurations, or helpful tips, I would really appreciate it!
Thanks,
Shaun