Hello Guest it is October 28, 2020, 01:42:53 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - jeremy72

Pages: 1
1
General Mach Discussion / Z axis stepper wont move.
« on: December 31, 2013, 02:09:39 PM »
I am new to mach 3 and cnc. I have everything laid out wired up and running except z axis. mach 3 plasma I have x and y movement but when I try z it does not move. I changed drivers and steppers around they all work. Is there a setting I am over looking or not understanding. The DRO I think is what its called is going up and down but nothing at the stepper. thanks ???

Pages: 1