1
General Mach Discussion / Tachus42 Drivers and motors works in Kcam 4 and Not working in Mach3
« on: December 20, 2013, 11:07:53 AM »
Hi dear friends, i bought tachus42 driver board months ago and it works with motors in mach3 but it burned after short period, and i replaced it with another one also tachus42 but from another local seller , but this time it doesn't works however i tried the xml file from the official website of Tachus42 , the seller supply the setting file for Kcam , i tried it and it works in kcam4 - the pins in kcam same as mach3 xml files from Driver website.
i attached the ports and pins in my pc and both of the software
this setting in Kcam
i attached the ports and pins in my pc and both of the software
this setting in Kcam