1
Third party software and hardware support forums. / HELP WITH OPTIMUM CNC CONTROLLER VI AND MACH3
« on: October 20, 2015, 06:02:08 AM »
Good Day,
I was wondering if any of the esteemed gentleman on this forum could help me with the setup of the above controller with Mach3.
As a novice I bought the Optimum BF20 Vario Mill and then converted it to CNC but never considered for a moment the control software that would be needed.
Mach 3 was a obvious and as far as I am concerned a good choice. Unfortunately getting information regarding spindle connections, touch plate connections, input and output activation for this specific hardware and software are not really forthcoming.
I will however write this down to my own inexperience and knowledge hence this mail.
in anticipation
I was wondering if any of the esteemed gentleman on this forum could help me with the setup of the above controller with Mach3.
As a novice I bought the Optimum BF20 Vario Mill and then converted it to CNC but never considered for a moment the control software that would be needed.
Mach 3 was a obvious and as far as I am concerned a good choice. Unfortunately getting information regarding spindle connections, touch plate connections, input and output activation for this specific hardware and software are not really forthcoming.
I will however write this down to my own inexperience and knowledge hence this mail.
in anticipation