Topics

1

General Mach Discussion / Help needed..can't get axis movement with keyboard

« on: December 08, 2013, 06:54:21 PM »

I currently have a problem with my mach 3.  I must have got the system out of config when I was trying to program three new stepper motors for a future project. I went back in to ports/pins and set it by basic set up as in the tutorial. I've tried about everything I can think of and can't get movement with the keyboard, I'm running a Stepperworld  FET 3 board. I'm thinking the pin config must be right because If I input a g-code and hit start the 3 axis run thru the program fine. It's just the issue I have no manual controls for jogging or setting z. Any help or suggestions would be greatly appreciated.