Hello Guest it is April 14, 2021, 04:19:08 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - vre

Pages: 1
1
General Mach Discussion / AC servos & mach3
« on: December 16, 2013, 02:28:21 PM »
What breakout board/motion controller need to control these servo drives from mach3 ?

http://www.dinodirect.com/ac-servo-motor-drive-controller-aasd-30a-p19512055.html
http://www.dinodirect.com/110st-m06030-6n-m-1-8kw-ac-servo-motor-drive-package-to-send-a-noodle-p14027512.html?DDID=3520-616

If possible i want board to support
>=3 axis
>=6 home-limiting switches (optical endstops)
1 optical spindle sync endstop (lathe spindle)
option to control spindle speed with vfd (inverter)
manual operation with joystick & jog speed control
option to switch on/off cooling fluid (to switch oil solenoid electric valve)
emergency stop
points in cutting tool
pause or reset cutting operation
ability to control tool turret

The pc has parallel & usb & ethernet port and i can install 32 or 64 bit windows.

thank you

Pages: 1