Guest
Show Posts
1
General Mach Discussion / No Output Voltage from Leadshine MX3660/ UC100
« on: November 20, 2013, 09:04:43 PM »
Hi Guys,
I'm new to this whole PC based CNC control stuff,but not to CNC (I've owned a CNC shop since 1983!). I have connected my laptop (running Mach3) via USB to a UC100 then into a Leanshine MX3660 3-axis drive. Everything have been configured correctly and I get no faults on the diognistics page and everything is correct on the UC100 in/out moniter... But I get no output voltage in any of the 4 output sets when the M3, M4, M7, M8 toggles are actuated. I also have the Pulse LEd enabled.
Am I doing something wrong or do i have a bad MX3660???
Thanks in advance for your help!
I'm new to this whole PC based CNC control stuff,but not to CNC (I've owned a CNC shop since 1983!). I have connected my laptop (running Mach3) via USB to a UC100 then into a Leanshine MX3660 3-axis drive. Everything have been configured correctly and I get no faults on the diognistics page and everything is correct on the UC100 in/out moniter... But I get no output voltage in any of the 4 output sets when the M3, M4, M7, M8 toggles are actuated. I also have the Pulse LEd enabled.
Am I doing something wrong or do i have a bad MX3660???
Thanks in advance for your help!