Hello Guest it is March 29, 2024, 05:33:15 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Hobbit13

Pages: 1
1
Hi,

Recently I'm got the idea to turn a small Proxxon translation table into a CNC machine. I've brought two new motors for the X/Y, and those work fine with Mach3. I also got an old stepper from a very old Hard Disk (Rodime 5.25" ca 10MB, ca 1982). See attached pictures.

I'm sure it's a two phase 6 wire motor, but I do not know how to determine the correct order of the wires.

The first phase is: Red / White / Black (with White the halfway common)
The second phase is: Yellow / Green / Blue (with Green the halfway common).

Resistance per phase is 36 Ohm (thus 18 Ohm between Red/White or White/Black).

I'm using a bipolar 4 wire stepper driver, can someone help to deduct which colors are A, A_, B and B_? The motor doesn't follow the standard color codings.

Any other info on the motor (voltage, torque etc.) is welcome!

Pages: 1