Hello Guest it is November 17, 2019, 08:12:35 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Criver

Pages: 1
1
General Mach Discussion / Cut steps +Y .250 each pass
« on: October 30, 2013, 12:46:14 PM »
I am a noob with a Zenbot Mini , aftermarket controller, Artcam and Mach 3.
As the program runs the second pass moves approx .250" in the +y direction the the third pass moves another .250" and so on.
I have only cut pink foam so far so I have not trashed any bits , but I need to fix this before I try to cut wood.
Any ideas what may be telling it to shift each pass?
Thanks

Pages: 1