Hello Guest it is November 15, 2019, 08:22:56 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - sdow

Pages: 1
1
CS-Lab / servo motors feedback resolver
« on: November 25, 2014, 08:46:53 PM »
Hi

I need a help ...i have a old cnc and i need to change the drivers ....my motors is servo motor 3 phase  400V  with feedback resolver   ... can you help me to chose the good driver for these motors ...i would like to connect it to sc-lab controllers ..

Thanks

2
CS-Lab / water and auto length tool
« on: July 13, 2014, 09:37:06 AM »
Hi

I have one question how i need to wire my switch (water )   to   cs-mio   and i would like to stop water when my cnc go on my auto length tool  and active water when it quit my auto length tool  ?

Can you help me .

Thanks

3
CS-Lab / mach3 over read and csmio-ip-a
« on: July 02, 2014, 11:08:34 AM »
Hi
i every time have light red on when i change speed in feed rate  .... if i click on reset i have 100% and not led green and no led red ... when i change  up or down speed ...i got a led red ?

thanks

4
CS-Lab / tuning motors
« on: June 06, 2014, 11:47:51 AM »
Hi

When connected my drive to cs-mio/ip-a  .... my motor started to run .... why ? Can you help me ?   When i try to click on auto tuning PID  ... i have error ...ePID....

Thanks

6
CS-Lab / tool setter
« on: November 07, 2013, 07:48:15 PM »
Hello

I never used the set tools  ....but have some questions ...  can i do that witch csmio and mach 3

i would every time when  mach3 ask me to change tools with windows pop (or similar processing ) to change tools manually   . After i change the tool and press ok .  The CNC go to tool setter  and continue the  process .

Thinks

7
General Mach Discussion / MR-J2S-A and Mach 3
« on: October 28, 2013, 07:22:02 PM »
Hi

I have motors and drivers Mitsubishi  ... but i am need a help  ...how i can connect this drivers to mach3 ... can you propose me some controllers non very expensive to tray this ...

Thinks

Pages: 1