Topics

1

CS-Lab / IP-S STEP/DIR Pin Change

« on: October 14, 2013, 09:25:29 PM »

Hi All,

I just bought an IP-S Controller.
followed the manual book that says I can pick any pin for my X,Y,Z axis' step/dir input..
somehow in my IP-S those pins are locked to pin# 1-6 so #1 as X step #2 as X dir and so on..
I tried to change the pin configuration through Mach3 but it stays the same.. although if i toggle the activelow setting it does toggle the voltage..

any idea how to fix this? should i reinstall everything? (as in mach3 and the cslab plugin?)

cheers