1
General Mach Discussion / A Little Help Please.
« on: March 05, 2010, 03:49:25 PM »
On my Taig mill when jogging my Z axis using the up and down arrow keys the motor intermittently freezes almost like it is binding and sometimes the up goes in the minus direction. Also the Z axis will not start moving unless it is jumpstarted by hand. Does anybody have an answer for these problems or any suggestions? Just a final note about the binding. When the controller is off and no power is to the motor I can freely turn the headstock up and down using the hand crank. I am having no problems at all with X & Y axis. Please could someone help me....