1
General Mach Discussion / Trying to notch 25mm 316 stainless may be use wizzards but don't know how
« on: June 30, 2014, 05:59:20 PM »
Hi all,
Hope very much one of you out there can help. I have a Triac, controlled by Mach3 and also have Lazycam.
I am wanting to do something like the in the link but notching 316 stainless 25mm diameter tube 2mm wall thickness. I want to notch the tube to fit over 25mm tube so 25 into 25 at 90 degrees. I need to do 14 bits so if anyone has any advice for a novice on how to best do this in Mach3 cutter choice, coolant and so I would be real grateful of the chance to learn from the experts. I think some help on Wizards would be handy as I have no idea on how to use them I can't find much on them in the Mach3 manual
https://www.youtube.com/watch?v=-rMVbR6e1TQ
Many thanks in advance for any help
Steve
Hope very much one of you out there can help. I have a Triac, controlled by Mach3 and also have Lazycam.
I am wanting to do something like the in the link but notching 316 stainless 25mm diameter tube 2mm wall thickness. I want to notch the tube to fit over 25mm tube so 25 into 25 at 90 degrees. I need to do 14 bits so if anyone has any advice for a novice on how to best do this in Mach3 cutter choice, coolant and so I would be real grateful of the chance to learn from the experts. I think some help on Wizards would be handy as I have no idea on how to use them I can't find much on them in the Mach3 manual
https://www.youtube.com/watch?v=-rMVbR6e1TQ
Many thanks in advance for any help
Steve