1
General Mach Discussion / Restarting a JOB
« on: October 23, 2013, 03:55:41 AM »
Hi All
one of my power points tripped which runs the motors the Mach PC was still working and one so I thought all I would do it say continue job well what it did it try go to the origin of where the code started - I lifted the Z axis so it would clear the part but it dropped the Z Axis and moved directly to the start point destroying the part in the process.
How do I set it up that the X & Y move with the Z set to home when in such a situation?
thank you
Mark
one of my power points tripped which runs the motors the Mach PC was still working and one so I thought all I would do it say continue job well what it did it try go to the origin of where the code started - I lifted the Z axis so it would clear the part but it dropped the Z Axis and moved directly to the start point destroying the part in the process.
How do I set it up that the X & Y move with the Z set to home when in such a situation?
thank you
Mark