Hello Guest it is December 07, 2022, 08:06:40 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - smarrocco

Pages: 1
General Mach Discussion / Mach3 forgets DRO values at shutdown....
« on: November 11, 2013, 02:03:04 PM »
....or does it fail to read them at startup?
It seems to happen pretty regularly that when I startup Mach3 after a proper shutdown that it will load random values for the XYZA DROs. I have no hardware connected to provide any such values. Is there a checkbox somewhere to remember the values that were last in the DROs for re-reading at next startup?

I have modified my default Mach screen (1024) by adding an additional Page that contains additional functions including some Cypress Basic functions. I noticed that the Left/Right/Up/Down keyboard keys do not "job" my mill's axis when my custom page is displayed, whereas they do function on some of the other Mach3-privided pages. I was thinkng that these hotkeys were global but apparently they are not.

Is it possible to "expand the range" of the hotkeys that are present on the first Mach3 screen (page 1) so that they will function on my additional page (page 61) as well?

Pages: 1