1
General Mach Discussion / My job wont show up on my table?
« on: October 22, 2016, 03:52:13 PM »
Hello
I changed the coordinates on my machine and the side that it homes to. I now have my gantry set up as X and length as Y, Questions are as follows
1) Stand at front of machine and look at the gantry and router when I press the up arrow the gantry moves back to the homing end.
2) On the 1st page of mach3 when I go to the full table on display mode it shows my work off the table left and lower of the table
Don
I changed the coordinates on my machine and the side that it homes to. I now have my gantry set up as X and length as Y, Questions are as follows
1) Stand at front of machine and look at the gantry and router when I press the up arrow the gantry moves back to the homing end.
2) On the 1st page of mach3 when I go to the full table on display mode it shows my work off the table left and lower of the table
Don