1
General Mach Discussion / running external programs triggered by mach3 events
« on: December 22, 2013, 05:23:47 PM »
Hello,
I'm in need of running an external program whenever mach3 turns on/off the spindle.
Seems like mach brains might work, but I couldnt figure out how to run any external programs.
So is it possible to run an external program based on mach events, if so how?
I'm in need of running an external program whenever mach3 turns on/off the spindle.
Seems like mach brains might work, but I couldnt figure out how to run any external programs.
So is it possible to run an external program based on mach events, if so how?