Hello Guest it is December 01, 2021, 02:02:04 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - cockneyrebel

Pages: 1
1
General Mach Discussion / spindle going the wrong way
« on: September 23, 2013, 03:47:16 PM »
Hi me again i have sorted all the other problems out that i have had  and now what the problem is the spindle going the wrong way round !!!! i am using mack3 and xinfutai vfd‏ inverter i am controling the spindle by this. so when i turn the control knob it gos the wrong way please can someone help before i go mad thanks Tom

2
General Mach Discussion / mack3 licence ?
« on: September 23, 2013, 04:12:31 AM »
hi i got mack3 which i got in janurary and the licence.i had to reinstall mack3 over the week end and downloaded mack3 of the web site and then put my licence in the folder and installed it.but now it justs come's up with demo.could anyon e help me out on this one many thanks Tom

3
General Mach Discussion / help with setting up spindle with mack3
« on: September 20, 2013, 05:03:56 AM »
Hi can someone please help me to setup my mack3 to control  my spindle i have a Xinfutai VFD to control it the spindle but i have not got a clue how to setup the software many thanks to you if you can help Tom

4
General Mach Discussion / help please setting up Xinfutai VFD‏
« on: September 19, 2013, 05:54:25 PM »
Hi can someone please help me set up my Xinfutai VFD‏ unit to run with mack3 and control my spindle i am quite new to this so if someone can help me please thanks

Pages: 1