1
General Mach Discussion / Y axis won't move in Job Step but work fine in Continous Mode?
« on: September 19, 2013, 03:24:33 AM »
My X and Z axises work fine in both Jog Step or Continous mode even at small increments. My Y axis is setup teh excat same way (i think). But the problem is that as soon as i switch the Jog Mode to Step Mode the Y axis won't move at all. X and Y moves fine. As soon as i switch back to Continous Mode again. All axises move fine again?
Makes no sense to me?
Makes no sense to me?