1
Show"N"Tell ( Your Machines) / Meccanicca Cortini - Mach3 - C11 BOB - Gecko G213V
« on: September 22, 2013, 06:12:33 PM »
Hi,
I've got this nice little mill that I converted to modern controller/driver/stepper setup.
After wiring it all up, everything moves the way it should.
Listen to the stepper motors as the program mills a circle tho, sounds like a car shifting 1,2,3 when acc/decc at the quadrants of the circle.
I can't get friendly with it... the transmission is toothed-belt. Can anybody hear something I should double check on ?
http://youtu.be/7EOwui47Moc
Thanks for any suggestions.
I'll post some more pictures of the setup when I get out of the shop
Cheers
Marco
I've got this nice little mill that I converted to modern controller/driver/stepper setup.
After wiring it all up, everything moves the way it should.
Listen to the stepper motors as the program mills a circle tho, sounds like a car shifting 1,2,3 when acc/decc at the quadrants of the circle.
I can't get friendly with it... the transmission is toothed-belt. Can anybody hear something I should double check on ?
http://youtu.be/7EOwui47Moc
Thanks for any suggestions.
I'll post some more pictures of the setup when I get out of the shop
Cheers
Marco