Topics

1

G-Code, CAD, and CAM discussions / help with mach 3 not running at g coded feedrate

« on: September 12, 2013, 04:19:43 PM »

this is the g code from mach 3

should it not run at 250?


it runs at like 1.93? I run past g codes and they work fine
it shows federate of 250 in mach 3 but does not run it

N0001 (Filename: circle gav.tap)
N0011 (Post processor: Mach3 plasma.scpost)
N0021 (Date: 12/09/2013)
N0031 G20 (Units: Inches)
N0041 G53 G90 G91.1 G40
N0051 F1
N0061 S500
N0071 (Part: circle gav)
N0081 (Operation: Outside Offset, LAYER1, T2: Jet tool)
N0091 M06 T2 F250.0  (Jet tool)
N0101 G00 Z0.3937
N0111 X1.9688 Y-0.2796
N0121 Z0.1181
N0131 M03
N0141 G04 P0.02
N0151 G01 Z0.0591 F3.937
N0161 Y-0.0296 F250.0
N0171 G03 X1.9687 Y-0.0296 I-0.0000 J1.9983
N0181 G01 X1.9688 Y-0.2796
N0191 M05
N0201 G00 Z0.3937
N0211 M05 M30