1
General Mach Discussion / mach w/ galil plugin and z plunge
« on: September 19, 2013, 04:58:42 PM »
i have a machine that i am adapting to run mach3. i have the x and y running great but my z axis is a air cylinder that is either up or down. i have been messing with this for a while and i cant figure out how to get the z to plunge. it is relay controlled and i was wondering if there is a way to make it use the cylinder anytime there is a negative z command? i dont know if i am explaining this correct or not. this machine is actually a router.