Hello Guest it is April 14, 2021, 01:38:25 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - dudz996

Pages: 1
1
General Mach Discussion / Mach3 help please / Steps jerking
« on: January 27, 2015, 03:05:11 AM »

 My 3 axis CNC works fine with Mach3. I had a 3 axis USB movement card and I have changed it to a standard 5 axis BOB as I thought there was a problem with the first board. But It still exists.
 If I load a large Gcode into Mach3, when I try to toggle the axis or zoom in on Mach3's graphic table display, the stepper motors slow down steps to almost individual steps. I ran a latency test on my PC, which the results were good. ( servo / max int 1011675, max jitter 15071  // Base max int 42076 // max jitter 19317 )

Any Ideas Please ?




2
General Mach Discussion / Mach3 digitizing probe not saving file
« on: September 08, 2013, 10:18:27 AM »
 I sure this is a common problem to new users of the digitizing wizard in Mach3.

I have just bought a probe for my cnc machine. All working as it should, but the txt file is always empty and shows 0 bytes when the wizard is finished. What am I doing wrong please ?

 ???

Pages: 1