Hello Guest it is June 27, 2019, 01:39:32 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - ckapus

Pages: 1
1
General Mach Discussion / Help with Mach 3
« on: August 27, 2013, 08:43:25 PM »
Hello, I'm having a problem with milling a circuit from within Mach3.

I have created a basic circuit in EagleCAD 6.5 and exported it using PCB-GCODE for use with Mach3. The problem I'm running into is the circuit is being milled at about 70% of it's original size -- the overall circuit is being reduced in size.

I have Mach3 setup in millimeters and the exported GCode is also set in millimeters. I have checked over all my setting within Mach3 and everything is set to what the manufacturer of the milling machines suggests it to be for Mach 3.

I'm not sure what I'm doing wrong and any help would be appreciated.

Thanks, Chris

Pages: 1