Hello Guest it is April 25, 2024, 03:37:59 PM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - jaument

Pages: 1
1
General Mach Discussion / Rookie Question
« on: August 19, 2013, 07:04:44 PM »
I am creating a simple profile using SolidWorks and SolidCam, when I create the NC file and open it in Mach 3, I get these crazy big green circles? They don't show up in SolidCAM simulate, but they do in the preview window. Any suggestions?

[

Pages: 1